2012

2012

Journal Papers:

  1. C. Sen, Y. Usama, T. Carciumaru, X. Lu, and N.C. Kar, “Design of Novel Wavelet based Transient Detection Unit for In-Vehicle Fault Determination and Hybrid Energy Utilization,” IEEE Transactions on Smart Grid, vol. 3, pp. 422-433, 2012.
  2. K.L.V. Iyer, X. Lu, K. Mukherjee, and N.C. Kar, “Novel Two-Axis Theory based Approach towards Parameter Determination of Line-Start Permanent Magnet Synchronous Machines, ” IEEE Transaction on Magnetics, vol. 48, pp. 4208-4211, 2012.
  3. X. Lu, K.L.V. Iyer, K. Mukherjee, and N.C. Kar,”A Wavelet/Particle Swarm Optimization based Voltage Regulation Scheme and Suitability Analysis of Copper- and Aluminum-rotor Induction Machines for Distributed Wind Power Generation,” IEEE Transactions on Smart Grid, vol. 3, pp. 1923-1934, 2012.
  4. S. Hamidifar and N.C. Kar, “A Novel Approach to Saturation Characteristics Modeling and Its Impact on Synchronous Machine Transient Stability Analysis,” IEEE Transactions on Energy Conversion, vol. 27, pp. 139-150, 2012.
  5. X. Lu, K.L.V. Iyer, K. Mukherjee, and N.C. Kar, “A Dual Purpose Triangular Neural Network Based Module for Monitoring and Protection in Bi-directional Off-board Level-3 Charging of EV/PHEV,” IEEE Transactions on Smart Grid, vol. 3, pp. 1670-1678, 2012.
  6. H.M. Jabr, K.L.V. Iyer, C. Sen and N.C. Kar, “Self-adjusting and Fuzzy Logic Gain Schedulers for Vector Control of Wind Driven Doubly-fed Indcution Generator,” International Journal of Environmental Studies (Taylor and Francis), vol. 69, pp. 299-313, 2012.
  7. K.L.V. Iyer and N.C. Kar, “Voltage and Frequency Regulation of Alumium- and Copper-Rotor SEIGs incorporating Proximity Effect,” International Journal of Environmental Studies (Taylor and Francis), vol. 69, pp. 314-337, 2012.

Conference Papers:

  1. D. Biswas, K. Mukherjee, and N.C. Kar, “Loss Minimization Control of a Vector Controlled Induction Motor for Electric Vehicle Applications,” in Proc. of the IEEE Transportation Electrification Conference and Expo, Detroit, USA, 2012.
  2. X. Lu, K.L.V. Iyer, K. Mukherjee, and N.C. Kar, “Development of a Bi-directional Off-board Level-3 Quick Charging Station for Electric Bus,” in Proc. of the IEEE Transportation Electrification Conference and Expo, Detroit, USA, 2012.
  3. S.M.M. Sangdehi, K.L.V. Iyer, K. Mukherjee, and N.C. Kar, “Short Term Power Demand Forecasting in Light and Heavy Duty Electric Vehicles Through Linear Prediction Method,” in Proc. of the IEEE Transportation Electrification Conference and Expo, Detroit, USA, 2012.
  4. S. Baldizzone, C. Novak, and N.C. Kar, “Experimental Investigations of Noise and Vibration in Electric Machines,” in Proc. of the IEEE Transportation Electrification Conference and Expo, Detroit, USA, 2012.
  5. Y. Li and N.C. Kar, “Investigating the Effects of Power Split PHEV Transmission Gear Ratio to Operation Cost,” in Proc. of the IEEE Transportation Electrification Conference and Expo, Detroit, USA, 2012.
  6. M. Kazerooni and N.C. Kar, “Impact Analysis of EV Battery Charging on the Power system Distribution Transformers,” in Proc. of the IEEE International Electric Vehicle Conf., South Carolina, USA, 2012.
  7. M. Kazerooni and N.C. Kar, “Optimal Load Management of EV Battery Charging and Optimization of Harmonic Impacts on Distribution Transformers,” in Proc. of the IEEE Canadian Conf. on Electrical and Computer Eng., Montreal, Canada, 2012.
  8. K. Mukherjee, K.L.V. Iyer, X. Lu, and N.C. Kar, “A Novel and Fundamental Approach towards Field and Damper Circuit Parameter Determination of Synchronous Machine,” in Proc. of the IEEE International Conference on Electric Machines, Marseille, France, 2012.
  9. K.L.V. Iyer, X. Lu, K. Mukherjee, and N.C. Kar, “Fault Detection in Copper-rotor SEIG System Using Artificial Neural Network for Distributed Wind Power Generation,” in Proc. of the IEEE International Conference on Electric Machines, Marseille, France, 2012.
  10. A. Labak and N.C. Kar, “Outer Rotor Switched Reluctance Motor Design for In-Wheel Drive of Electric Bus Application,” in Proc. of IEEE International Conference on Electric Machines, Marseille, France, 2012.
  11. B. Esteban, M. Sid-Ahmed, and N.C. Kar, “Review of Primary Circuit Topologies for Wireless EV Charging Systems,” Presented at the Electric Vehicle Conference & Trade Show, Montreal, Canada, 2012.
  12. X. Lu, K. Mukherjee and N.C. Kar, “Study and Detection of Demagnetization in Line Start Permanent Magnet Synchronous Machines Using Artificial Neural Network,” in Proc. of the IEEE International Conference on Electric Machines & Systems, Sapporo, Japan, 2012.
  13. K.L.V. Iyer, X. Lu, K. Mukherjee, and N.C. Kar, “Novel Two-Axis Theory based Approach towards Parameter Determination of Line-Start Permanent Magnet Synchronous Machines, ” in Proc. of the IEEE INTERMAG, Vancouver, Canada, 2012.